Bort 91276018, Руководство пользователя

Страница: 5 / 27

4
(See Figure2)
Figure 2 - Adjusting nozzle for fan pattern
(not applicable on some nozzle)
A narrow stream has high impact force on the cleaning
surface and results in maximum deep cleaning in a con-
centrated area. However, this narrow high impact spray
must be used cautiously, as it may damage some sur-
faces.
Figure 3 - Narrow high impact stream
A wide fan pattern will distribute the impact of the water
over a larger area, resulting in excellent cleaning action
with a reduced risk of surface damage, Large surface
areas can be cleaned more quickly using a wide fan pat-
tern.
Figure 4 - Wide fan pattern
NOZZLE CLEANING INSTRUCTIONS
A clogged or partially clogged nozzle can cause a sig-
nificant reduction of water coming out of the nozzle and
cause the unit to pulsate while spraying. To clean out the
nozzle:
• Turn off and unplug unit.
• Turn off water supply. Relieve any pressure trapped in
the hose by squeezing trigger 2-3 times.
• Separate lance from gun.
• Rotate nozzle to the narrow stream setting. This opens
up the fan blades.
• Using included tip cleaner, or an unfolded paper clip,
insert wire into the nozzle hole and move back and forth
until debris is dislodged. (See Figure 5.)
Figure 5 - Insert tip cleaner in nozzle hole and move
back and forth until debris is dislodged
Align holes on the bottom of the pressure cleaner as
shown and tighten the 2 screws, and fit the wheel to the
machine, as the fig.
CONNECTION
1. Attach the high pressure hose to the pressure water
outlet of the machine.
2. Attach the spray handle to the high pressure hose.
Prior to operating the machine please ensure that the
high pressure hose has been completely uncoiled.
Whilst the machine is in operation the hose MUST not
loop.
3. Mount the nozzle or any other equipment you want
to use.
4. Connect the machine to the water and power supplies.
INSTALLATION, ELECTRICAL
AND WATER CONNECTIONS
1. pressure cleaner
2. water supply hose
3. water connection
4. water inlet
5. high pressure tube
6. water outlet(backside)
7. spray gun
8. power supply
* No. 2, 3, 8 are not included
PRE-OPERATION
ADJUSTING FAN PATTERN
The angle of spray coming out of the lance may be ad-
justed on some lances by rotating the nozzle. This will
vary the spray pattern from approximately a 0° narrow
high impact stream to a 60° wide fan spray.
Autogoods “130”
130.com.ua