- 12 -
HINGED PLEXIGLASS COVERS
NOTE: Complete the assembly of the hinged periodical shelf before installing
the plexiglass covers.
1. Installation is the same for both the one-piece and the two-piece covers.
See Figure 27A.
2. Hinged periodical shelves are provided with the piano hinges welded
on.
NOTE: Steps 3 and 4 below can be replaced by using double-sided tape on
the underside of the hinge to fasten plexiglass cover. Tape not included.
3. Center plexiglass sheet under hinge. Using pre-drilled holes in hinge as
a template, drill holes through plexiglass cover.
4. Pop rivet the cover in place through the hinge, plexiglass and #10 flat
washer with a 3/16 Lo-pro pop rivet. See Figure 27B.
FIGURE 27A
FIGURE 27B
FIGURE 27C
FIGURE 28A
FIGURE 29
DETAIL
FIGURE 28B
WALL HUNG COLUMN STRIPS -
use instead of welded frame against wall
1. Lag or anchor the column strip where required; normally 36" on center. See Figures 28A, 28B and 29.
2. Be sure the column strip is plumb and that the tops are level. Lags and anchors are not supplied and must meet local building codes. See
Figures 28A and 29.
14251-00
07884-00
