BorMann 045274, Руководство пользователя, Страница: 18 / 156

EN
WWW.NIKOLAOUTOOLS.GR
18
AC application
(1) Start the engine and make sure the pilot lamp turns on. If it does not, the filament may be burnt out.
(2) The speed of generator must reach rated speed (lever at top). For rated speed of generator, please see main technical specifications
and parameters at the relevant chapter Section.
(3) The Generator can load when the indicator of voltmeter shows at 230(+-10%) (50Hz) on the panel of control box.
(4) Plug in the appliance.
Caution: Do not start two or more machines simultaneously. Start them one by one. Do not use floodlights together with
other machines.
(5) Be sure that all appliances are in good working condition before connecting them to the generator, if an appliance begins to oper -
ate abnormally, becomes sluggish, or stops suddenly, turn off the generator immediately. Then disconnect the appliance and examine
it for signs of malfunction. If overloading of the circuit trips the AC circuit protector, reduce the electrical load on the circuit, and wait
a few minutes before resuming operation. If the indication of voltmeter is too low or too high, stop the machine and examine it for
cause of malfunction.
DC application
The DC terminal may be used for charging 12 volt automative-type batteries only. (1) When using automotive-type batteries with
battery cables, be sure to disconnect the minus pole battery cable from the battery before charging. (2) Start the engine.(3) Connect
the charging cable to the battery terminals and the DC terminals of generator. Connect the positive battery terminal to the positive
generator terminal. Do not reverse the charging cables, or serious damage to the generator and/or battery may occur. Do not allow the
free ends of the cable to touch each other. If this occurs, it will be short circuit the battery. When a large capacity battery is charged,
excessive current flows(the value varies depending on the discharging condition), and the fuse for the direct current will burn out. (4)
Batteries produce explosive gases. Keep sparks, flames and cigarettes well away. To prevent the possibility of creating a spark near the
battery, always connect the charging cables to battery first and only then to the generator. When disconnecting, you should disconnect
the cables at the generator first. (5) Charge the battery in a well ventilated place. Before charging, remove the cap from each cell of
the battery. Discontinue charging if the electrolyte temperature exceeds 45°C.
Caution: Do not attempt to start an automobile engine while the generator is still connected to the battery. Do not use DC 12 volt
and AC at the same time.
Engine speed
lever
Stopping the generator
Please bear in mind that for stopping (as well as
starting) the ΒGB9000 generator, you should carefully
follow the initial guidelines. Stopping and starting
ΒGB9500 is simply done by the respective switch, no
further detailed explanation is required.