BorMann 017196, Перевод оригинальной инструкции

Страница: 16 / 73

16
as possible into the chuck opening.
• Close the chuck (1). Check that the drill bit is
secure in the chuck (1).
• Check at regular intervals that the drill bit or
tool is secure (pull the mains plug).
6. Operation
6.1 ON/OFF switch (Fig. 7/Item 5)
• First fit a suitable drill bit into the tool (see 5.3).
•
Connect the mains plug to a suitable socket.
•
Position the drill in the position you wish to
drill.
To switch on:
Press the ON/OFF switch (5)
Continuous operation:
Secure the ON/OFF switch (5) with the locking
button (4).
To switch off:
Press the ON/OFF switch (5) briefly.
6.2 Adjusting the speed (Fig. 7/Item 5)
• You can infinitely vary the speed whilst using
the tool.
• Select the speed by applying a greater or lesser
pressure to the ON/OFF switch (5).
• Select the correct speed: The most suitable
speed depends on the workpiece, the type of
use and the drill bit used.
•
Low pressure on the ON/OFF switch (5):
Lower speed (suitable for: small screws and soft
materials)
• Greater pressure on the ON/OFF switch (5):
Higher speed (suitable for large/long screws
and hard materials)
Tip:
Start drilling holes at low speed. Then
increase the speed in stages.
Benefits:
The drill bit is easier to control when starting
the hole and will not slide away.
•
You avoid drilling messy holes (for example in
tiles).
6.3 Preselecting the speed (Fig. 7/Item 6)
•
The speed setting ring (6) enables you to
define the maximum speed. The ON/OFF switch
(5) can only be pressed to the defined maximum
speed setting.
• Set the speed using the setting ring (6) on the
ON/OFF switch (5).
• Do not attempt to make this setting whilst the
drill is in use.
6.4 Clockwise/Counter-clockwise switch
(Fig. 7/Item 7)
•
Change switch position only when the drill is
at a standstill!
•
Switch the direction of the hammer drill using
the clockwise/counter-clockwise switch (7):
Direction Switch position
Clockwise (forwards and drill)
Pushed in to the right
Counter-clockwise (reverse) Pushed in to the left
6.5 Drill / hammer drill selector switch
(Fig. 8/Item 3)
Change switch position only when the drill is
at a standstill!
Drill
Drill / hammer drill selector switch (3) in the drill
position. (Position A)
Use for: Wood, metal, plastic
Hammer drill
Drill / hammer drill selector switch (3) in the
hammer drill position. (Position B)
Use for: Concrete, rock, masonry
6.6 Defining the speed range (Fig. 9)
The speed selector switch (9) enables you to
work within a specific speed range.