BORLA PERFORMANCE INDUSTRIES
5901 Edison Dr.
Oxnard, Ca. 93033
TITLE: 07 Dodge Caliber R/T Installation
Instructions
PART NO. A-35390
Page 4 of 4
Borla Performance Cat-Back
Exhaust
System Installation
1. Place a clamp over the expanded end of the front muffler assem-
bly and set it into position as shown in figure 4 making sure to
install the hanger into the rubber isolator. Do Not tighten the
clamp.
2. Place a clamp over the expanded end of the intermediate pipe and
set it into position as shown in figure 5. Do Not tighten the
clamp.
3. Place a clamp over the expanded end of the rear muffler assem-
bly and set it into position as shown in figure 6. Do Not tighten
the clamp.
4. Install the ground strap onto the rear muffler as shown in figure
7.
5. Check your exhaust system for proper clearance under the vehi-
cle and also for tip alignment.
6. Once position has been determined to be correct, tighten the Ac-
cuseal™ clamps to 32-35 ft. lbs. making sure the clamp opening
is not over any of the notches in the pipe.
7. Before starting your vehicle, make sure to check all wires, hoses,
brake lines, body parts and tires for safe clearance from the ex-
haust system.
8. Start vehicle and check for any leaks. If any leaks are found, de-
termine cause (such as loose hardware or incorrectly positioned
clamp) and repair as necessary.
Figure 4
Figure 5
Note: When you first start your vehicle after the installation of
your new Borla Performance Exhaust System, there may be
some smoke and fumes coming from the system. This is a pro-
tective oil based coating used in the manufacturing of man-
drel bent performance exhaust tubing. This is not a problem
and will disappear within a very short period of time after the
exhaust has reached normal operating temperatures.
Figure 6
Figure 7
