Borg & Overstrom u2 40L, Инструкция по установке и эксплуатации, Страница: 11 / 32

Borg & Overström GB 11 Install & Operation Manual
Undercounter Installation & Water Connection
1 2
5 6
7 8
9
Locate the machine in a
suitable enclosure, ensuring
that the supplied ventilation kit
can be installed.
Connect the u2 tap to the
Chilled, Ambient and Sparkling
water outlets.
Connect the CO2 supply from
gas regulator, ensuring the
pressure is set to 58 PSI (4
bar), and turn on the supply.
Connect the chiller to the
water supply and open the
mains supply isolation valve.
Connect the unit to the
electrical supply and turn on.
After approximately 10
minutes, the compressor and
fan will stop as the chiller has
reached its normal operating
temperature.
The carbonator should be
purged of air by activating the
sparkling water dispense for
approximately 20 seconds.
Isolate the water supply
and activate the sparkling
water dispense. When the
water system has emptied,
allow gas to be expelled for
approximately 5 seconds.
Immediately after this 5
second period restore the
water supply and allow the
system to refill.
Dispense ambient, still and
sparkling water, in turn,
to purge any air from the
system. The time to do this
may vary depending on the
length of pipe between the
unit and the tap.
4 3
10
mins
40 PSI
20
secs