191
Connection of the power supply cable
Important! This cooktop must be connected to the electricity supply only
by an authorised person.
To connect the feeder cable to the hob it is necessary to carry out the
following operations:
*
Unhook the terminal board cover “
A
” by inserting a screwdriver into the two
hooks “
B
” (fig. 2.2). Open completely the terminal block cover “A”.
*
Unscrew the screw “
C
”, then unhook the cable clamp “
D
” by inserting a
screwdriver into the hook “
E
”. Remove completely the cable clamp “
D
”
(fig. 2.2).
*
Connect the phase, neutral and earth wires to terminal board “F” according
to the diagrams in fig. 2.3; the U bolts “
G
” (fig. 2.2) shall be used as
indicated in the diagrams in fig. 2.3 (they are supplied already fitted to the
terminals or inside the terminal board, behind the cover).
*
Strain the feeder cable and block it with cable clamp “
D
” (by hooking hook
“
E
” and screwing screw “
C
”).
*
Close the cover “
A
” of the terminal board “
F
” (check the two hooks “
B
” are
correctly hooked).
Important
To connect the power supply cable DO NOT unscrew the screws fixing
the cover plate behind the terminal block.
If the supply cord (not supplied with the appliance) is damaged, it must
be replaced by the manufacturer or its service agent or a similarly
qualified person in order to avoid a hazard.
EN
User guide - Installation advice
