89
Installation
www.bora.com
EN
1
1
2
Fig. 9.15
Securing the appliance
[1]
Oven chamber seal
[2]
Fixing screw
X
Open the door.
X
Pull the oven seal away from the top left [1] and
top right [1] corners so that the fixing screw [2] in
each corner is accessible.
O
Turning the fixing screw (4 mm Allen key) causes
the levelling shim on the corresponding side to
move outwards and press against the locking plate.
X
Tighten the screw until the shim is positioned
correctly.
X
Do the same on the other side.
X
Moisten the seal with water.
X
Press the oven chamber seal back inside the groove.
X
Check that the oven chamber seal is positioned
correctly all the way round.
X
Check that the appliance is installed correctly.
Fitter the odour filter
X
Take the new odour filter out of its packaging.
X
Tap on “Maintenance” .
X
Tap on “Filter change” .
X
Proceed as shown when you press the
“Instructions” button.
9.7
Ventilation
i
Installation must not take place without
return flow apertures of >160cm² in the plinth
area and trim.
1
1
≥30
Fig. 9.16
Ventilation
[1]
Return flow aperture > 160 cm²
X
Provide for return flow apertures, each of
>160 cm², in the plinth area [1] and in the trim on
the unit [1].
