EN
16
Installation
www.bora.com
5 Installation
X
X
Observe all safety and warning information
(see the Safety section).
X
X
Follow the enclosed manufacturer’s information.
INFO
The cooktop must not be installed above
cooling devices, dishwashers, stoves, baking
ovens, washing machines or driers.
INFO
The contact surface of the worktops and wall
sealing strips must be made of a heat-resistant
material (up to approx. 100 °C).
INFO
Worktop cut-outs must be moisture-sealed
using suitable means or, where necessary,
fitted with a thermal insulator.
5.1 Checking the scope of delivery
Name
Quantity
Control knob
2
Operating and installation instructions
1
Cooktop fixing screws
4
Height adjustment plate set
1
Cooktop
1
Cooktop mounting straps
4
Control knob cable
2
Automatic extraction cable
1
Glass ceramic panel cleaning instructions
1
Glass ceramic scraper
1
Tab. 5.1 Scope of delivery
X
X
Check the scope of delivery for damage and make sure
it is complete.
X
X
If there are any missing or damaged parts, please
notify BORA After Sales Service immediately.
X
X
Do not under any circumstances install parts which are
damaged.
X
X
Dispose of transport packaging in the proper manner
(see the Decommissioning and Disposal section).
5.2 Tool and aids
The following tools are required for the correct installation
of the cooktop:
Q
Q
Pencil
Q
Q
Measurement equipment:
Q
Q
Drill or cordless drill with Forstner bit Ø 50mm
Q
Q
Screwdriver/hexolobular internal key (Torx) 20
Q
Q
Silicone sealant for sealing cutting surfaces
5.3 Assembly instructions
5.3.1 Safety clearances
X
X
Maintain the following safety clearances:
1
3
2
Fig. 5.1
Minimum clearances
[1]
Minimum clearance of 50 mm at the back from of the
worktop cut-out to the rear edge of the wor0°).
[2]
Minimum clearance of 50 mm from the left and right
of the worktop cut-out to the adjacent cabinet or
wall. For ergonomic reasons and to ensure efficient
cooktop extraction, a minimum clearance of 300 mm is
recommended.
[3]
Minimum clearance of 600 mm between the worktop and
the wall unit.
5.4 Cut-out dimensions
Preparing the worktop
X
X
Create the worktop cut-out taking into account the
specified cut-out dimensions.
X
X
Make sure that the cutting surfaces of the worktops
are properly sealed.
X
X
Comply with the instructions of the worktop
manufacturer.
5.4.1 Worktop overhang
≥74
x
Fig. 5.2
Worktop overhang
