EN
29
Installation
www.bora.com
Programming the device power management
Prerequisites:
Q
Q
The cooktop is switched off.
Q
Q
All cooking zones are switched off.
X
X
Separate the device from the voltage supply using
the LS switch, fuses, automatic circuit breakers or
contactors.
Q
Q
After re-establishing the voltage supply, you have up to
two minutes to open the service menu.
X
X
Re-connect the appliance to the voltage supply.
X
X
Press and hold the multi-function button.
X
X
Briefly press the timer button.
Q
Q
A short signal tone will sound and the front half of the
setting ring lights up.
X
X
Now release the multi-function button.
X
X
Swipe the setting ring in a circular, clockwise motion
to move from 3 to 8.
0
3
8
Fig. 6.40 Opening the service menu
Q
Q
C0
is displayed intermittently with
C
and
O
on the left
front cooking zone indicator.
Q
Q
0
is displayed in the left back cooking zone indicator
(factory setting).
X
X
Use the multi-function button to select the menu level
C0
.
X
X
Press any button on the setting ring to change the
setting from
0
to
1
.
X
X
Press the timer button to save the change.
Q
Q
The cooktop is ready for use.
Menu setting
C0
Cooking zone power
Left side
Right side
0
3.7 kW
3.7 kW
1
2.2 kW
2.2 kW
Tab. 6.3 Device power management
6.9 Connect the external switch
contact
INFO
The Home-In and Home-Out communication
connection must only be connected by a
certified specialist. He/she also assumes
responsibility for the proper installation and
commissioning.
4
4
1
1
3
2
Fig. 6.39 Electrical connections of the cooktop
[1]
Bore holes
[2]
Power supply
[3]
Connection control
[4]
Cable mounting clip
X
X
Connect the power supply cable to the power supply [2]
of the cooktop with cooktopFig. 6.36r in accordance
with the relevant connection diagram (see fig. 6.36
Connection diagram).
X
X
For a 1-phase or 2-phase connection, connect the
relevant contacts with the BKAS connector clip
(in scope of delivery).
X
X
Fasten the cable mounting clips [3] to the designated
bore holes [1] either on the left or right hand side for
the cable routing to the rear.
X
X
Ensure that the cable is not caught or damaged and is
not able to touch any hot hobs.
X
X
Verify that the installation was done correctly.
X
X
Switch on the main switch/automatic circuit breaker.
X
X
Put the cooktop into operation (see the Operation
chapter).
X
X
Check all the functions are working correctly.
6.8 Device power management
(overall power reduction)
INFO
The device power management function can be
set in the service menu. Accessing the service
menu and changing the power management
setting may only be performed by a certified
specialist.
The total device power can be reduced to 4.4 kW upon
initial commissioning if the required electrical power
cannot be provided at the installation site.
The connection must always be equipped with 20 A fuse
protection as a minimum.
