Page 7
3BE490017NU – 04/19
BONNET GRANDE CUISINE
Rue des Frères Lumière - Z.I Mitry Compans
F-77292 MITRY MORY Cedex
3 CLEANING
WARNING:
Regular and thorough cleaning will ensure prolonged service life
♦
UNDER NO CIRCUMSTANCES SHOULD CLEANING CHEMICALS BE USED ON SURFACES THAT ARE OVER 60°C.
The result will be serious surface discolouration and damage.
♦
High pressure jets or hoses should not be used for cleaning.
♦
The warranty will not cover any issues arising from non-compliance with the above.
♦
The use of this equipment as a sink is strictly prohibited.
♦
The appliance must be isolated electrically during cleaning or maintenance and when replacing parts.
Cleaning must only be carried out when the well is lowered (horizontal). Heating elements and working parts are thus protected against
splashing.
Optimal cleaning:
Use water with soap or any other neutral and nonabrasive detergent product, avoid using metal wool pads. Rinse thoroughly after cleaning.
If using low pressure jets or foam guns, do not squirt water onto/into the burnt gas flue vent or the ventilation apertures (gas appliance).
-
Set temperature at 50°C, remove most of the food residues.
-
Close the lid, put a little degreasing agent on the panelling. Avoid getting liquids into the burnt gas outlet vents (gas appliance).
-
Open the lid, wash the inside of the lid and the well and finally the lower panelling.
-
Close the lid when rinsing the panelling.
-
Rinse the inside of the lid. Slightly tilt the well and rinse it.
-
Rinse the well and inner panelling thoroughly.
-
Wipe the lid seal.
NOTE: It is highly recommended that you dry inside the base of the well. Stagnant water mixed with even the smallest amounts of cleaning agents or
chlorine will, in time, result in irreversible corrosion of the well base.
4 PREVENTIVE MAINTENANCE
To ensure the proper, long-lasting and safe functioning of the equipment, it should be serviced by qualified personnel from our company.
Subject
D
a
il
y
W
e
e
k
ly
M
o
n
th
ly
E
v
e
ry
y
e
a
r
(o
r
1
5
0
0
h
o
u
rs
)
Recommendations
For all equipment
Clean external surfaces
x
Use the correct dose of cleaning product; Do not use
abrasive products.
Visual check of the facia labels
x
Must not have deteriorated (Overheated, crack...) Do not
douse with water if there is any deterioration of the facia
labels; Alert the after sales service at the first signs of
deterioration.
Bratt pan lid seal (if fitted)
x
Use the correct dose of cleaning product; rinse thoroughly,
do not use abrasive products.
Visual check of the lid seal (if fitted)
x
If deteriorated alert the after sales service
Periodic maintenance by the after sales service
x
Caution: The appliance must be isolated electrically during cleaning or maintenance and when replacing parts.
