BONNET PRO Mini Max Mule 220R Скачать руководство пользователя страница 9

9

SafetY PreCautionS

this machine is intended for commercial use only. it 
is designed exclusively to clean carpets in an indoor 
environment and is not constructed for any other use. use 
only recommended cleaning chemicals from Bonnet Pro.

all operators must read, understand and practice the 
following safety precautions.

The following warning alert symbol and the “FOR SAFETY” heading 
are used throughout this manual as indicated in their description:

WarninG: to warn of hazards or unsafe
practices which could result in severe personal
injury or death.

for SafetY: to identify actions which must be
followed for safe operation of equipment.

failure to follow these warnings may result in
personal injury, electrical shock, fire or explosion.

WarninG: fire or explosion Hazard:

•  Never Use Flammable Liquids Or Operate Machine in Or 

near flammable Liquids, Vapors or Combustible Dusts.

  This machine is not equipped with an explosion
  proof motor. The electric motor will spark upon
  start up and during operation which could cause a
  flash fire or explosion if machine is used in an area
  where flammable vapors/liquids or combustible
  dusts are present.

WarninG: electrical Hazard. Do not operate
With Damaged Power Cord. Do not Modify Plug.
unplug Power Cord Before Servicing Machine
if the supply cord is damaged or broken, it must
be replaced by the manufacturer or its service
agent or a similarly qualified person in order to
avoid a hazard or oSHa fines.

WarninG: electrical Shock Hazard.
Do not use outdoors. Do not expose to rain.
Store indoors.

The following information signals potentially
dangerous conditions to the operator or
equipment:

for SafetY:

1. Do not operate machine:

•  With flammable liquids or near flammable
vapors as an explosion or flash fire may occur.

•  Unless trained and authorized.
•  Unless operator manual is read and understood.
•  Unless cord is properly grounded.
•  With damaged cord or plug.
•  If not in proper operating condition.
•  In outdoor areas.
•  In standing water.
•  With the use of an extension cord.

2. Before starting machine:

•  Make sure all safety devices are in place and operate properly.
•  Remove loose objects on floor to prevent dangerous projectiles if 

struck by spinning pad.

•  Place wet floor signs as needed.

3. When using machine:

•  Stay clear of spinning pad.
•  Do not pull machine by plug or cord.
•  Do not run machine over cord.
•  Do not pull cord around sharp edges or corners.
•  Do not close doors on cord.
•  Do not unplug by pulling on cord.
•  Do not stretch cord.
•  Do not handle plug with wet hands.
•  Keep cord away from heated surfaces.
•  Follow mixing and handling instructions on chemical containers.
•  Never activate the power when the handle is in the upright position.
•  Do not release handles until pad comes to a complete stop.
•  Go slow on inclines and slippery surfaces.
•  Wear non-slip shoes.
•  Report machine damage or faulty operation immediately.
•  Never allow children to play on or around.
•  Do not ride on machine.

4. Before leaving or servicing machine:

•  Turn off machine.
•  Unplug cord from wall outlet.

5. When servicing machine:

•  Unplug cord from wall outlet.
•  Avoid moving parts. Do not wear loose jackets, shirts, or sleeves.
•  Use manufacturer supplied or approved replacement parts.
•  All repairs must be performed by a qualified service person.
•  Do not modify the machine from its original design.

6. When transporting machine:

•  Unplug cord from wall outlet.
•  Get assistance when lifting machine.
•  Use  tie--down  straps  to  secure  machine  to  truck  or  trailer.All 

repairs must be performed by a qualified service person.

operation

Содержание Mini Max Mule 220R



















Отзывы: