BONNET PRO Mini Max Mule 220R, Руководство владельца/оператора

Страница: 14 / 18

14
Do not over tighten handle clamp
This will cause the clamp to fail and is not covered under warranty. To
adjust your handle clamp, tighten it as much that is needed to prevent
the handle from slipping during transportation but no more. Again
do not over tighten as this may prematurely wear out the cam on the
locking handle.
Tighten your handle adjustment clamp (with the handle in the open
or unlocked position) until the clamp will not slide over the handle
tube. Then back off the plastic nut`s pressure very slowly in small
movements just enough for the handle to gild through the clamp.
This should give you enough clamping force to lock the handle for
transportation and enough movement to easily adjust you handle.
If you have done this and still have a problem the handle clamp may
be twisted (if the machine fell as an example) or you may have over
tightened the clamp and scratched or dimpled the handle tube.
Bonnet Pro suggests using your hand and not your foot to
engage and disengage the handle clamp. Your hands extra
sensitivity should allow you to prevent over tightening and
premature failure of the assembly.
Keep the handle tube clean and do not use/ leave oil on it as this will
force you to over tighten the clamp.
However you can use penetrating oil on the handle or a carburetor
type cleaner to free the handle and inside of the collar from foreign
debris or soil build up. This is the most common problem. After this
is done wipe the handle dry and if it still does not move freely when
it is adjusted correctly you can go back over the handle tube with
some fine steel wool. As long a nothing is bent this should correct the
problem and should be done as needed for maintenance.
WARnInG: When going up stairs:
It is always the operator’s responsibility to assess the safety of moving
their MiniMax up stairs to make sure conditions are safe. Always
remove the chemical jug if full and the detachable power cord to
lighten the machines weight. The operator should also make sure the
steps treads are deep enough to support the foot print of the Mini`s
wheels. When possible, if machine is carried up steps two people to
lift and carry is recommended.
using the detachable hose and sprayer:
After the coil hose extension is plugged into the female quick connect
turn the ball valve with the yellow handle to the 9oclock position when
standing in front of the machine. This will divert solution from the
front sprayer. Next, place the pump in the continuous on position by
pressing the toggle switch to the most downward position, one click
down off of center. Now when you pull the trigger on your spray gun
it will operate the on/off of the demand pump.
Steps and Coil Hose