Bonica BC988, Руководство по эксплуатации

Страница: 9 / 15

– 7 –
- Add a 100 gram weight on the outside in any angular position.
- Press START .
- The machine is calibrated at the end of the cycle. The display reads “END CAL”.
Remove the 100 gram weight from the wheel, which can now be balanced with a further cycle.
The values that the machine records form this self-calibration operation are automatically stored in a special memory which also
maintains them when the machine is switched off, with storage lasting for about 10 years, so the machine will be ready for
correct functioning every time it is switched on.
However, the self-calibration operation can be repeated as often as you like or whenever the correct functioning of the machine
is in doubt.
Plane and Used on Aluminum Alloy Wheels. Weight is to be applied on the Center
clamped to the Outer Edge.
For balancing standard steel or alloy wheels using
clip-on weights attached to inner and outer wheel edges.
(No Symbol Illuminated)
DYNAMIC
3.10 STATIC-ALU functions
:
ALU1 :For balancing of the light alloy rims with application of adhesive weights on the rim
shoulders
ALU2 : For balancing wheel rims in light alloy with application of the inner side adhesive
weight. Position of the inner side weight is the on shown in the figure
ALU3 :
Fig. 5
(For balancing wheels of motorcycle, in light alloy or special construction forms)
St .: STATIC correction is required for motorcycle wheels or when it is not possible to place
the counterweights on both sides of the wheel rim.
Press key ALU to select the desired function. For each function, the microprocessor
elaborates the real values of the compensating weight corrected on the basis of the position
of the correction weight and memorizes them quickly on the unbalance displays.
-
3.11 Optimizing the unbalance
The optimizing operation enables you to reduce the amount of weight to add to the wheel in order to balance it. In many cases,
an improvement of the residual eccentricity on the tire can also be achieved.
- Press key OPT, The display reads “r.S.”
- Press START The machine runs a measuring cycle.
- The display gives an instruction to turn the tire on the wheel rim. Make a reference mark on the adapter and wheel rim
with chalk, so as to be able to refit the wheel rim on the bead of the tire in the same position.
- Use a tire changer to rotate the tire through 180 on the wheel rim.
- Fit the wheel rim back onto the adapter in the same position as before.
- Press START. The machine runs a second measuring cycle.