provided.
DISTANCE:
find
out
the
measure
between
the
machine
and
the
weights
application
point
on
the
wheel
rim
and
set
by
means
of
“a”
– 6 –
.
3.7 Note for balancing of motorcycle
wheels dynamically
-
Slip the extension onto the distance
measurer.
-
Extract the measurer until the
extension touches the inner side of
the wheel rim.
-
Read the value “ a ” on the scale,
set it manually using the key 9,
value “a+5” (scale base 25 cm).
+5 cm
3.8 Wheel balancing
Fig.4
-
Close the guard.
-
Press the START key.
-
The wheel is accelerated automatically to balancing speed and then braked; displays 3 and 5 read the unbalance values.
-
Displays 1 and 2 read the correction position with LEDs. If all the LEDs are lit, the correction weight must be put at the top
of the vertical axis.
IMPORTANT:
An unbalance value reading below 10-12 grams (0.4-0.5 oz) is normally sufficient for good balancing.
With this balancing machine, it is easy to balance to a tolerance of only 5 grams (0.2 oz) or less.
THRESHOLD KEY:
FINE
The correction of residual unbalance below 5 grams (0.2 oz) can be read whenever necessary (wheels for special uses) by
pressing this key with the machine at a standstill.
Display 3 and 5 for unbalances below 5 grams (0.2 oz) in normal conditions.
3.9 Self calibration methods
-
Fit any wheel to the shaft, even one that is not balanced, although it is advisable to use one with “average” dimensions.
-
Set the exact dimensions of the wheel fitted.
ATTENTION:
any error in setting the dimensions will mean that the machine is not correctly calibrated, so all the subsequent
measurements will be faulty until the machine is next calibrated with correct measurements.
-
Press F + C .
- 6 -
-
Until the positioning LED’s change from flashing into steady.
-
Press START
– 6 –
