Bongioanni IDEA Series, Инструкции по установке и обслуживанию

Страница: 23 / 24

EDIZIONE 5/97
FLUE SAFETY THERMOSTAT 3.5
RE-STARTING THE BOILER
The activation of the flue safety thermostat is indicated by a red signal lamp on the control
facia corresponding to the symbol “chimney obstructed”.
To re-start the boiler proceed as follows:
- turn off power supply
- remove the casing front panel to reach the flue thermostat reset button
- remove (unscrew) the plastic cover on the reset button
- push down the red reset button
- refit the plastic cover and re-assemble the casing front panel
- turn on power supply.
WARNING: should the flue safety thermostat trip more than three times, it is abso-
lutely vital to call for a Qualified Service Engineer to check for the possible cause of
failure. Should the chimney draught be inadequate, then corrective action must be
taken.
PROHIBITION: the flue safety thermostat has been pre-setted and its sensor positioned
in such a way that the device will trip in accordance with the Regulations in force.
Therefore it is absolutely forbidden to change either the phial position or electrical con-
nection. It is also forbidden to replace the flue safety thermostat with another of non-origi-
nal supply.
17