19
GB
INSTALLATION
The.appliance.must.be.installed.by.qualified.staff.working.in.ac-
cordance.with.the.regulations.in.force.
Before.installing,.ensure.that.the.appliance.is.correctly.preset.for.
the.local.distribution.conditions.(gas.type.and.pressure).The.preset-
tings.of.this.appliance.are.indicated.on.the.nameplate.shown.on.
the.cover.This.appliance.is.not.connected.to.a.flue.gas.extractor.
device..It.must.be.installed.and.connected.in.accordance.with.the.
regulations.in.force.This.appliance.may.only.be.installed.and.may.
only.operate.in.rooms.permanently.ventilated.in.accordance.with.
national.regulations.in.force.
SAFETY ChAIN
! In order to prevent the appliance from overturning acciden-
taly, for example in case of a children climbing onto the oven
door, the safety chains MUST be installed !
The.cooker.is.provided.with.safety.chains.that.must.be.fixed.with.a.
screw.(not.supplied.as.accessory).on.the.wall.behind.the.appliance,.
at.the.same.height.as.the.fixing.point.on.the.appliance.
Make.sure.that.the.chains.are.fixed.in.the.back.of.the.cooker,.as.
shown.in.the.fig..9,.in.such.way.to.be.tight.and.parallel.to.the.floor.
!.When.the.installation.process.is.complete,.the.chains.must.be.
kept.in.tension!
VENTILATION
The. rooms. in. which. gas. appliances. are. installed. must. be. well.
ventilated.in.order.to.allow.correct.gas.combustion.and.ventilation.
The.air.flow.necessary.for.combustion.is.at.least.2.m
3
/h.for.each.
kW.of.rated.power.
POSITIONING
Remove.the.packaging.accessories,.including.the.films.covering.the.
chrome-plated.and.stainless.steel.parts,.from.the.cooker..
Position.the.cooker.in.a.dry,.convenient.and.draft-free.place..Keep.
at.an.appropriate.distance.from.walls.which.may.be.damaged.by.
heat.(wood,.linoleum,.paper,.etc.).
The.cooker.may.be.free-standing.(class.1).or.between.two.units.
(in.class.2.st.2-1).the.sides.of.which.must.withstand.a.temperature.
of.100°C.and.which.must.not.be.higher.than.the.working.table.
FITTING ThE FEET (LEVELLING)
Cookers.are.equipped.with.adjustable.feet.to.be.screwed.into.their.
front.and.rear.corners.respectively..The.feet.allow.the.height.of.the.
appliance.to.be.adjusted,.in.order.to.set.it.flush.with.the.adjoining.
unit,.to.level.it.with.other.worktops.and.to.ensure.even.distribution.
of.the.liquids.in.pans..See.fig..3.
BALANCING ThE LID
Models.equipped.with.plate.glass.lids.are.fitted.with.special.ba-
lanced.springs..These.are.fitted.into.the.hinge.to.provide.smooth,.
gentle.lid.closure.
GAS CYLINDER CONNECTION
Make. the. connection. to. the. butane-propane. cylinder. using. an.
approved.hose.from.75.to.80.cm.long,.following.the.route.shown.
in.figure.4.The.hose.must.not.touch.the.side.near.the.oven..The.
maximum.gas.cylinder.size.is.diameter.31.cm.and.height.60.cm,.
with.capacity.from.10.to.13.kg.
CONNECTING TO ThE GAS SUPPLY
Before.connecting.the.cooker,.check.that.it.is.preset.for.the.gas.
to.be.used..Otherwise,.make.the.conversion.as.described.in.the.
section.headed.“Adapting.to.different.gas.types”...The.connection.
is.on.the.right;.if.the.pipe.has.to.pass.behind.the.cooker,.it.must.
be.kept.low.down.where.the.temperature.is.about.50.degrees.C.
-.Rigid.connection.(see.Figure.5,.diagram.D):
. The.connection.to.the.mains.gas.supply.may.be.made.using.a.
rigid.metal.pipe.(D)...Remove.the.hose.connector.and.screw.the.
rigid. union. onto. the. threaded. connection. of. the. gas. train.. The.
union.for.rigid.connection.is.amongst.the.cooker.accessories.
Installation
-.Connection.using.a.rubber.hose.(see.Figure.5,.diagrams.B.and.
C):
. Connect.a.rubber.hose.carrying.the.conformity.mark.currently.in.
force.to.the.hose.connector..The.hose.must.be.replaced.at.the.
date.indicated,.and.must.be.secured.at.both.ends.using.standard.
hose.clamps..It.must.be.absolutely.accessible.to.allow.its.condition.
to.be.checked.along.its.entire.length.
-.Connection.using.a.metal.hose.(see.Figure.5,.diagram.D):
. Make.the.connection.using.a.hose.which.complies.with.national.
standards,.screwing.it.onto.the.connector.with.a.ring.seal,.which.
is.delivered.amongst.the.cooker.accessories.
-.After.installation,.check.that.all.connections.are.airtight.
-.For.operation.with.butane/propane,.check.that.the.gas.pressure.
is.as.indicated.on.the.nameplate.
IMPORTANT:
-.Use.only.standard.rubber.hoses...For.LPG,.use.a.hose.which.
complies.with.the.national.regulations.in.force.
-.Avoid.sharp.bends.in.the.pipe.and.keep.it.well.away.from.hot.
surfaces.
References.to.the.regulations.covering.the.gas.connection.to.the.
appliance:.ISO.7-1.
ADAPTING TO DIFFERENT TYPES OF GAS
If.the.cooker.is.not.already.preset.to.operate.with.the.type.of.gas.
available,.it.must.be.converted...Proceed.as.follows:
-.Replace.the.injectors.(see.table.on.page.18);
-.regulate.the.primary.air.flow;
-.regulate.the.minimum.settings.
N.B.:.every.time.you.change.the.type.of.gas,.indicate.the.new.type.
of.gas.on.the.serial.number.label.
REPLACING ThE hOB BURNER INJECTORS (Fig. 6)
-.Remove.the.grid,.the.burner.caps.(A),..and.the.burners.(B);
-.Unscrew.and.remove.the.injector.in.the.bottom.of.each.injector.
holder.(C);
-.replace.the.injector.in.accordance.with.the.table.in.page.18.using.
a.7.mm.socket.wrench,..tighten.and.screw.right.down;
-.check.that.the.system.is.gas-tight;
-.replace.the.burners,.the.burner.caps.and.the.grid.
IMPORTANT:
-.Never.over-tighten.the.injectors;
-.after.replacing,.check.that.all.the.injectors.are.airtight.
SETTING hOB BURNER MINIMUM LEVELS
If.the.cooker.is.to.work.on.bottled.gas.(butane/propane),.the.tap.
by-pass.must.be.screwed.right.down.The.cooker.may.be.equipped.
with.type.A.taps,.with.by-pass.inside.(accessed.by.inserting.a.small.
screwdriver.into.the.rod).or.type.B.taps,.with.by-pass.on.the.outside.
on.the.right.(accessed.directly)..See.figure.7.
If.the.cooker.is.to.work.on.natural.gas,.proceed.as.follows.for.both.
types.of.tap:
-.Ignite.the.burner.at.maximum.flame;
-.pull.off.the.knob,.without.using.a.lever.against.the.control.panel,.
which.might.be.damaged;
-.access.the.by-pass.with.a.small.screwdriver.and.back.off.by.about.
3.turns.(turning.the.screwdriver.anti-clockwise);
-.turn.the.tap.rod.anti-clockwise.again.until.it.stops:.the.burner.will.
be.at.maximum.flame;
-.screw.the.by-pass.slowly.back.in,.without.pushing.the.screw-driver,.
until.the.flame.has.apparently.shrunk.to.1/4.of.the.maximum.size,.
checking.that.it.is.sufficiently.stable.even.in.quite.strong.draughts.
CONNECTING TO ThE ELECTRICAL MAINS
Before.making.the.connection,.check.that:
-.the.mains.voltage.is.as.indicated.on.the.nameplate;
-.the.earth.connection.is.in.good.working.order.
If.the.appliance.power.lead.is.not.fitted.with.a.plug,.use.an.approved.
standard.type,.remembering.that:
-.the.green-yellow.wire.must.be.used.for.the.earth.connection;
-.the.blue.wire.is.the.neutral;
