68
– Detach bulb and replace.
Properly reinstall removed parts in the
reverse order of their removal.
CAUTION:
On applicable models,
never touch glass portion of an halo-
gen bulb with bare fingers, it short-
ens its operating life. If glass is
touched, clean it with isopropyl al-
cohol which will not leave a film on
the bulb.
Adjust beam aiming as follows:
Turn knobs to adjust beam height ori-
entation to your convenience.
1. Headlight
2. Beam height adjustment
Taillight
Unscrew lens screws to expose bulb.
Push bulb in and hold while turning
counterclockwise to release.
Install the new bulb by first pushing in
while turning clockwise.
1. Lens
2. Screws
Indicator Lamp Replacement
Removal
Remove the control panel.
Unplug wires on indicator lamp.
Press both taps then push indicator
lamp out of hole.
1. Tabs
Installation
For installation, reverse the removal
procedure.
V02I06Y
2
1
V02A06Y
2
2
1
V02A0FY
1
1
vmo2000_001b.fm Page 68 Friday, September 17, 1999 1:21 PM
Содержание DS 7404
