Pre-Operation Check
WARNING
The pre-operation check is very im-
portant prior to operating the vehi-
cle. Always check the proper oper-
ation of critical controls, safety fea-
tures and mechanical components
before starting. If not done, severe
injury or death might occur.
Before using this vehicle, the operator
should always:
• Apply parking brake and check if it
operates properly.
• Check tire pressure and condition.
• Check wheels and bearings for
wear and damage.
• Check location of controls and en-
sure they work properly.
• Verify if steering operates freely.
• Activate throttle control lever sever-
al times to ensure it operates freely.
It must return to idle position when
released.
• Activate the brake levers and brake
pedal to make sure the brakes fully
apply. Levers and pedal must fully
return when released.
• Ensure transmission lever is work-
ing then reset in NEUTRAL position.
• Check drive chain for adjustment
and lubrication.
• Check sprockets for wear and dam-
ages.
• Check fuel, oil and coolant levels.
• Check for oil leaks on the en-
gine/transmission and drive train
components.
• Ensure fuel valve is in fully open
position (ON).
• Clean headlamps and taillight.
• Ensure front access compartment
cover is properly latched.
• Ensure seat is properly tightened.
• If you transport cargo, respect load
capacity.
• If you are pulling a trailer or other
equipment, ensure it respects the
tongue capacity and towing capac-
ity. Ensure trailer is properly se-
cured to hitch.
• Look and feel for loose parts while
engine is off. Check fasteners.
• Ensure the path of travel is free of
persons and obstacles.
• Check operation of ignition switch,
start button, engine stop switch
and headlamps.
• Start engine, remove parking brake
and drive forward slowly a few feet
then apply all brakes individually to
test them.
Correct any problem you may have
found before riding. See an autho-
rized Bombardier ATV dealer as nec-
essary.
____________
SAFETY INFORMATION
___________
41
Содержание DS 250
