/ BM-GE-520 Owner’s Manual Ver.01-2009
Page 10
4.INITIAL OPERATION
4.1 Preparation for initial operation
* Put BM-GE-520 machine and filter units on to the surface to be processed
* Fit the appropriate diamond grinding cap wheel or polishing pad that is required for this
particulate process.
* Using correct cable wire, connect the machine and the dust connect to the power supply
Point, these electric supply points should be protected and equipped with a FL-switch.
(Residual current operated device).
* Check the extension cable for external damages
* Check the dust hose damages
* Connect the grinding machine and dust collector units with the flexible hose. Use hose
clamps at the connectors.
* Make sure the dust bin of the dust collector units is empty
If problem with the current supply arise during the assembly or the start up, call
a qualified person for help. Work on electrical equipment may only be undertaken
by a qualified personnel.
4.2 Switched on the machine
* Connect the machine to the electric inlet with a extension cable
* Press down the handle until the polishing pad or diamond cup wheel rises approximately
10 cm from the ground.
* Rotate the speed adjust bottom to right speed
* Then let down the grinding disc on the surface and begin the work. Move the machine
forwarder or reverse dependent on the work.
4.3 Speed adjust
Operator can adjust the speed with the speed the adjust wheel, on the control panel will display the
blades rotate speed. Maximum blades speed is 600RPM
