BOMANN TSG 7402.1, Инструкция по эксплуатации

Страница: 70 / 124

70
Water hardness
Setting →
Display Salt cons. /
cycle
°dH Mmol/l
23-34 4.1-6.0 H5 20 g
35-55 6.1-9.8 H6. 40 g
NOTE:
°dH: German degree of hardness
Factory setting: H3
Fill in the salt
CAUTION:

Only refill the salt container when the salt warning
lamp is lighting.

During filling the salt container, salt and water can
escape. Start a program immediately after you
have filled the container to prevent corrosion.

Remove the dishwasher basket and unscrew the
lid of the salt container.

Add about 130 g of salt by using the supplied
funnel tube.

Full fill the salt container with water (just before
the first use).

Screw the lid firmly on again after filling the con-
tainer.

Depending on salt resolution, the warning lamp
usually disappears immediately after filling.
B. Fill in detergent
Function of detergent
Detergents with its chemical ingredients are neces-
sary to remove dirt, crush dirt and transport it out of
the dishwasher. The most commercially, high-quality
cleaning agents are suitable for this purpose.
Detergent
Normally new pulverized detergent is without phos-
phate. Thus, the water softener function of phos-
phate is not given. In this case we recommend filling
salt in the salt container even when the hardness of
water is only 6°dH. If detergents without phosphate
are used in the case of hard water often white spots
appear on dishes and glasses. In this case add more
detergent to reach better results. Detergents without
chlorine do only bleach a little. Strong and colored
spot will not be removed completely. In this case
choose a program with a higher temperature.
Detergent tablets (Tabs)
Dishwasher tablets from different manufacturers
dissolve at different rates. It is possible that they will
not fully dissolve in programs with short running time
and low water temperature and thus does not reach
their full productive efficiency. To ensure the com-
plete removal of detergent residues, we recommend
choosing rinse programs with long running times and
high-water temperature. Always follow the manufac-
turer's instructions!
Fill in the detergent
NOTE:

Always add the detergent just before starting the
rinse cycle, otherwise it could get damp and will
not dissolve properly.

You’ll find information about the amount of deter-
gent for the respective programs in the „Program
table“.
Note that depending on the degree of soil-
ing and water hardness differences are possible.
Refill the detergent before starting of each rinse cycle
according to the instructions in the "Program table".
The appliance requires less
detergent than commercially
appliances. Normally one
tablespoon of detergent is
enough for a normally dirty
rinse load.