BOMANN TSG 7402.1, Инструкция по эксплуатации

Страница: 68 / 124

68
Installation location

Place the appliance so that all controls are easily
to reach, and the appliance door can open without
being impeded.

Take care of a solid and horizontal position of the
appliance.

Power cord and water hoses may not kinked or
squashed.

Avoid the installation:
-
near heaters, next to a stove, direct sunlight or
any other heat sources;
-
at locations with high humidity (e.g. outdoors),
as metal parts would be susceptible to corro-
sion under such circumstances;
-
in rooms where the temperature could drop
below freezing. Do not expose the appliance
any weather.
-
near volatile or flammable materials (e.g. gas,
fuel, alcohol, paint, etc.).
Water connection
CAUTION:

The Installation of the water supply must conform
to the local laws and regulations.

The appliance is not suitable for hot water supply.

Use the new supplied hose set to connect the
appliance to the water supply. Do not reuse old or
used connection sets.

If the water pipe is new or long time not used,
ensure before connecting to the water system,
that the water is clear and free from contamina-
tion.
Notes on inlet hose safety system (delivery scope
depending on model)
The safety system consists of a double-walled inlet
hose. It guarantees to cut off the water supply when
leakage of the inner hose. Switching off the water
supply leads over an electronic contact.
If necessary, you can order an inlet hose safety sys-
tem from your dealer or in our online accessories
shop,
www.bomann-germarny.de . To order, use the
reference number found under “Technical Data”.
Set up drainage

Attach the drainage hose to the appliance back.
The connector is provided with clamps and must
be fixed with a screwdriver
.

Secure the end of the hose securely in a sink or
bucket. Fix the drain hose with suction cups.
Set up water supply
You can fill the appliance with water in two ways:
Permanent connection via the tap
NOTE:
The water pressure must be between 0.04-1.0 MPa.
With higher pressure: use a pressure regulator.

Connect the water inlet hose to a water thread
with ¾“. Screw the hose firmly in the direction of
the screw thread; pay attention for a tight fit.

Connect the other end of the inlet hose to the inlet
valve on the appliance back; pay attention for a
tight fit too.