BOMANN EHBC 7930, Инструкция по эксплуатации

Страница: 7 / 24

7
1
Residual heat
indicator
2 Ø15.5 cm / 1200 W
3 Ø16.5/27.0 cm /
900/1100 W –
Roasting zone
4
Ø15.5 cm / 1200 W
5
Ø15.0/19.0 cm /
700/1000 W –
Double cooking
zone
Delivery scope
1x oven
tray
1x set of side
racks
1x grill
grid
mounting
screws
Installation
The built-in oven set is designed for installation in
standard kitchen units.
WARNING:
The installation and the connection to the main power
may only be performed by an authorized specialist.
CAUTION:
The worktop, the cabinet, veneers, plastic coatings,
used adhesives etc. must be sufficient heat-resistant.
NOTE: Recommendation!

When installing, ask another person to assist.

Wear protective gloves to avoid injuries at possi-
ble sharp edges.

When carrying the appliance use the hollows at
the housing sides.

Hob and oven must be from the same manufac-
turer and marked with the same type designation.

Do not install the appliance directly next to refrig-
erators of freezers. The escaping heat would re-
sult in an unnecessary increase of energy con-
sumption of those appliances.

Make sure that the oven and the hob are located
centrally to each other.
Safety distances
CAUTION:
Make sure that adequate air circulations ensured,
and the ventilation slots are not blocked. Follow ap-
propriate safety distances!

The appliance must be installed so that heat can
be dissipated. The ventilation openings (D) and
(E) must not be blocked.

To ensure a sufficient cooling air supply, no heat
protection strips may be installed.

The distance between the hob and an extractor
hood must be at least as large as specified in the
instructions of the extractor hood!

There must be a minimum distance below the cut-
out. In this area are not allowed heat-sensitive ob-
jects (cabinet, drawer, etc.). Any existing side
walls or drawer boxes must be sawed out or re-
moved accordingly.
A 760 mm
B 50 mm
C 20 mm (min.)
D Air intake 35 mm
E Air outlet 5 mm
Cabinet opening and appliance dimensions
Prepare the cabinet opening according to the dimen-
sional drawings.