Bomag BPR 35/60, Инструкция по эксплуатации и техническому обслуживанию

Страница: 26 / 63

Operation
BOMAG 27 BPR 35/60
l
If the engine does not start during the first at-
tempt, repeat the starting process.
Fig. 20
l
As the engine warms up open the lever (Fig.
20) of the choke slowly.
Fig. 21
l
Set the throttle lever (Fig. 21) to position
"MIN".
l
Run the engine warm for approx. 1 to 2 min-
utes in idle speed.
Note i
Operation of the vibratory plate can be started as
soon as the engine responds to short throttle com-
mands.
Fig. 22
l
If the engine stops again after approx. 3 to 5
seconds, close the choke again with the lever
(Fig. 22) and repeat the starting process.
Engine "drowned"
Note
i
When the choke is closed and the starter rope is
pulled several times, the engine draws in too much
fuel and will probably not start.
Remedy
l
Close the fuel cock.
l
Open the choke.
l
Set the throttle lever to full speed position.
l
Operate the recoil starter until the engine
starts.
Note
i
If the engine does not start after 10 to 20 attempts
l
Open the choke.
l
Set the throttle lever to full speed position.
l
pull off the spark plug socket.
l
unscrew the spark plug.
l
operate the starter several times.
l
Dry the spark plug with a clean cloth or blow it
dry with compressed air. If necessary clean
with a wire brush.
l
Screw the spark plug back in and plug the
spark plug socket back on.
l
Repeat the starting procedure.
Go to
Discount-Equipment.com
to
order your parts