Bolton Tools ZX1048P, Инструкция по эксплуатации

Страница: 8 / 38

200mm depth hole needed under the vertical lead-screw on the ground.
Ⅳ
.Operation instruction
1.preparation before start
You
’
d better consult operation instruction before starting. Familiarize
yourself with the structure of the machine and master the uses of each part
and operating manual.
Before starting the machine,clean away rust inhibitor and dirty on the
smooth,then smear it with lubricating oil,especially on guide,guide screw
and other contact surfaces which have relative shift.
First of all, check the mains voltage see if it accord with provide
data,check electrical equipment,earthed wire must be in a good
condition;and the clamping structure is clamping structure is clamped well.
2. adjustment of main-axle speed
The speed of main-axle is adjusted by the motor and two cone pulley.
The speed has six
grades,speed adjustment handle and combined switch control the speed of
this machine.
C
hoose your needed speed according to the instruction on the
speed plate. see details on data plate of speed.
3. Adjustment of angle of inclination of main axle box
If you need inclination of main-axle box,loose the four locking
screws,which on left and
right side of the main axle box.
K
eep the same resistance,(note:Not loose
too much of the four screw)use spanner,rotate the adjustment apparatus of
rotary of machine head,make the machine head inclination to such degree
angle,then lock the screws.