Bolton Tools ZX1048P, Инструкция по эксплуатации

Страница: 9 / 38

4. Adjustment if rotary of working table
If you need rotary in aclination of working table in horizontal plane
loose horizontal
feeding handle,rotary the working table to such degree angle and then tight
the rotary plate locking screw.
5.Lifting and locking working table
Loose lift locking bolt and lift locking screw-nail, the lift
handle,put the working table in needed position and then lock them.
6. Moving in length and breadth and locking of working table
(1)vertical feeding by hand and locking:
Loose the two vertical locking screw-nail,lock the hand wheel(left hand
wheel or right hand wheel)on each side if the working table, then you can
get vertical shift,if you do not need shift,lock the screw nail.
(2)vertical power feeding:
We can equip a power feeding apparatus on the right side if the working
table according to customer
’
s requirement(Note:you must loose the vertical
locking first).see details on operating manual of power feeding apparatus.
(3)Horizontal,shift and locking:
Loose the two horizontal feeding screw-nails on the left side of sliding
block,rock horizontal feeding handle,but if you do not need horizontal
shift,lock the screw-nails.
Eventually,loose the parts which need moving and lock the parts which don ’ t
need moving.
7.Operating of main-axle
(1)Fast feeding of main-axle
Loose sleeve locking handle and pull out the micro-feeding clutch handle,
rotate the operating handle, the we can get fast feeding.