Bolin Technology D Series, Руководство пользователя

Страница: 31 / 47

31
TILT DIR (TILT DIRECTION):
Camera tilt up and down orientation setting, options: Normal/Invert
TRACE MEMORY
Trace Memory is a function used to record pan/tilt/zoom operations
controlled by remote commander or a remote controller, which can be
played back as required. Up to 100 pan/tilt/zoom commands can be
recorded for up to 60 seconds.
•
TRACE NO: Select the TRACE number to record, playback or
delete.
•
PLAY TIMES: How to playback the recorded operations, can
be set to Once or Unlimited.
o
Once: The recorded trace memory will only run one time, then stop.
o
Unlimited: The recorded trace memory will loop unlimited times until leaving Trace Memory
mode or manual PTZ movement is triggered.
•
RECORD: Record operations.
•
MEMORY: Play or delete the recorded operations.
Recording Trace Memory (pan/tilt/zoom operations)
•
Select the trace number you want to record in TRACE NO.
•
Move the cursor to RECORD and press the HOME button (or Joystick right click).
*Setting menu (enter to record) is display at the top left corner of the screen
•
Move the camera position to the Start Position where you want the Trace to start from.
*Recording status is display at the top of the screen
•
Call preset 1 to start the trace recording
•
Perform the pan/tilt/zoom operations you want to record, during recording, elapsed commands number
at the top of the screen increases in increments of 1 when the camera received one command.
NOTE:
If using the remote controller, pan/tilt/zoom operations can
’t be performed simultaneously.
If using the joystick controller
, pan/tilt/zoom operations can’t be performed simultaneously
•
Call preset 1 to finish and stop the trace recording
NOTE:
The recording automatically stops after the maximum recording time has elapsed.
Playing Trace Memory (pan/tilt/zoom operations)
•
Select the recorded trace number you want to play in TRACE NO.
•
Move the cursor to MEMORY, select PLAY and press HOME button (or Joystick Enter button (the
button is located on the top of the joystick) to begin playback.
NOTE:
Playback stops if a pan/tilt/zoom operation is performed during playback by using the remote controller
or a joystick controller.
Deleting recorded Trace Memory (pan/tilt/zoom operations)
•
Select the trace number you want to delete in TRACE NO.
•
Move the cursor to MEMORY, select DELETE and press HOME button, it will display
“DELETE
TRACE
YES”, press HOME button again, the specific trace recording will be deleted.
SYSTEM MENU
PELCO ID
When using RS485 (PELCO P/D) control, Set
Camera ID to the address that you want to control
to. This value is from 1-255.
IR-RECEIVE (Infrared Signal Reception)
When this is set to OFF, the camera does not
receive the signal from the infrared remote
controller.
Be sure to keep it set to ON when you use the
infrared remote controller.
Note
You cannot set IR-RECEIVE to OFF when you
operate the menu using the infrared remote
controller. To set it to OFF, use the appropriate
EXPOSURE
WHITE BALANCE
PICTURE
PAN TILT ZOOM
→
SYSTEM
STATUS
OSD
PELCO ID 001
IR-RECEIVE ON
DISPLAY INFO ON
PRESET SETTINGS
COLOR SPACE YUV
AUDIO
FACTORY RESET
TALLY MODE OFF
RELOAD PRESET 1
ON
VIDEO FMT 1080p60
SV: VOC260B37040AA006
SYSTEM MENU
TRACE NO 1
PLAY TIMES ONCE
RECORD
MEMORY PLAY
Trace Memory