Bohman 6 BT 70, Руководство оператора

Страница: 42 / 72

ENGLISH
MAINTENANCE INSTRUCTIONS
! DANGER
Never perform any maintenance operations without first disconnecting the bat -
teries.
Maintenance on the electrical circuit and all other operations not explicitly de-
scribed in this manual must be performed by specialised personnel only, in
compliance with current safety legislation and as described in the maintenance
manual.
! DANGER
Before lifting/rotating the tank to access the compartment, its contents must
first be emptied, then insert the safety bracket in position to prevent the tank
from accidentally closing again, see chapter “SAFETY INFORMATION”.
Maintenance - General rules
Performing regular maintenance according to the Manufacturer’s instructions im-
proves performance and extends the working life of the machine.
When cleaning the machine, observe the following precautions:
► Avoid using pressure washers. Water could penetrate the electrical compart-
ment or motors leading to damage or short circuits.
► Do not use steam to avoid the heat warping plastic parts.
► Do not use solvents or hydrocarbon based products. These can damage the
cowling and rubber components.
Cleaning the suction motor air filter
Open the lid of the dirty water tank by releasing the clamp lever, then remove the
filter from its housing (fig. 15 - Ref 1) and wash it under running water or using the
detergent dispensed by the machine; dry the filter thoroughly before repositioning it
in the housing.
Cleaning the debris container
Open the dirty water tank lid, then empty the debris accumulated in the container (fig.
15-ref. 2); if needing to wash the container, remove it by lifting it out and then clean it.
Cleaning the dirty water tank float
Open the dirty water tank lid, then remove the debris container by lifting it out (fig. 15-ref. 2), turn the
float protector (fig. 15-ref. 3) and then clean the float; make sure that the float slides freely on its pin.
Cleaning the water/detergent tank filter
To clean the filter, proceed as follows:
► Unscrew the filter cap (fig. 17-ref. 1), remove the filter/hose union (fig. 17-ref. 2, then wash
under running water or using the same detergent as used on the machine.
► Replace the filter in its housing, making sure it is correctly positioned and screw the cover
back on.
1
2
3
15
17
FILTER
1-2
19