0014 00
BOH-PM-07-4
Chapter 4 Rev. 7.01
0014 00-1
OPERATOR MAINTENANCE INSTRUCTIONS
FPU
®
SYSTEMS OPERATION MANUAL
(INCLUDING REPAIR PARTS & SPECIAL TOOL LIST)
MODELS FPU-8-4/BOH-CARGO-12-3 & FPU-20-3
BOH FPU Field Pack-up Units
CLEANING AND LUBRICATING
INITIAL SETUP:
Materiel/Parts
References
Rags, Water, Detergent
None
Personnel Required
Equipment Condition
One
FPU SYSTEMS Set-up
CLEANING AND LUBRICATING
Cleaning and Lubricating of the FPU is performed to keep the FPU and its associated equipment in good
operating condition. The cleaning and lubrication of the FPU can be conducted along with the
Preventative Maintenance Checks and Services (PMCS) procedures described in (WP 0013 00). Specific
areas described below need to be cleaned after an operational event or periodically if stored/staged
outside of a fixed facility to keep the container, modules, and accessories performing as designed.
Cleaning also assists in maintaining the condition of the materiel stored within the system. Any damage
discovered when cleaning and/or lubricating that cannot be corrected using the troubleshooting
procedures described in (WP 0011 00) should be reported to maintenance for corrective action.
Table 1 Cleaning
SURFACE
OIL/GREASE
SALT/MUD/DIRT
DEBRIS
RUST/CORROSION
Exterior and Interior
Walls (All)
Detergent, Water,
Rags
Soapy Water, Brush,
Rags
Corrosion Removal
Compound and Wire Brush,
Dry Rag, Coat with Lube Oil
or Spot Paint
Door Seals
Damp and Dry Rags
Damp and Dry Rags
N/A
Module Cradles, FPU
Floor
Detergent, Water,
Rags (Remove,
clean, and replace
rubber pad into
footing)
Soapy Water, Brush,
Rags (Remove, clean
and replace rubber pad
into footing)
Corrosion Removal
Compound and Wire Brush,
Dry Rags, Coat with Lube
Oil or Spot Paint (Remove,
clean, and replace rubber
pad into module cradle
footing)
Container Door Hinges
N/A
Brush, Rag and
lubricate as needed to
ensure door hinges
travel freely
Corrosion Removal
Compound and Wire Brush,
Dry Rags and Lubricate as
needed
Door Retaining Straps
Detergent, Water,
Rags
Detergent, Water, Rags
N/A
Pallet Ledge Locking
Rod
N/A
Brush, Rag and
lubricate as needed to
prevent rust buildup on
threads
Corrosion Removal
Compound and Wire Brush,
Dry Rags and Lubricate as
needed
Содержание BOH-CARGO-12-3
