0013 00
BOH-PM-07-4
Chapter 4 Rev. 7.01
0013 00-1
OPERATOR MAINTENANCE INSTRUCTIONS
FPU
®
SYSTEMS OPERATION MANUAL
(INCLUDING REPAIR PARTS & SPECIAL TOOL LIST)
MODELS FPU-8-4/BOH-CARGO-12-3 & FPU-20-3
BOH FPU Field Pack-up Units
PMCS TABLE
INITIAL SETUP:
Materiel/Parts
References
Rags, Water
None
Personnel Required
Equipment Condition
One
FPU SYSTEMS Set-up
Table 1 Preventative Maintenance Checks and Services for the FPU SYSTEMS
PMCS B (Before), D (During), A (After), W (Weekly), M (Monthly)
B D A W M
Inspection Item and Procedure
Equipment Not
Ready/Available If
1
*
*
*
Doors, Walls
Check all doors and walls for cracks, dents,
holes, or loose/missing hardware.
Missing doors, punctures,
damage that would cause
hazard or injury.
*
Lubricate hinges, locks, as required.
Hinges and locks do not
operate smoothly.
2
*
*
Exterior
Check all exterior surfaces for cracks, dents that
effect the operation of the FPU SYSTEM or its
modules. Check for accumulations of dirt, debris,
ice, snow, or salt. Clean as required.
Check Horizontal Interconnectors for proper
function, tightness and debris. Clean as required
and replace if not functioning properly.
Damage or malfunction that
would cause the FPU
SYSTEM from operating
properly such as Horizontal
Interconnectors not
tightening properly which can
cause hazard or injury.
3
*
*
Interior
Check floor for dirt and debris. Clean with broom
or rags as required. Check module cradles in
FPU SYSTEM floor for cracks or missing\rubber
pads. Schedule cracked cradles for repair.
Check center ISO locks for cracks or missing
items. Check module-locking levers for missing
or loose cotter pins. Replace or tighten as
necessary.
Check roof access steps for cracks or missing
components. Replace as necessary.
Module cradles missing or
damaged so that module
does not seat properly,
center ISO twist locks are
broken or missing or roof
access steps cracked or
missing which can cause
hazard or injury.
4
*
*
Data Plates
Check plates for legibility, damage and/or
missing. Clean with water and rag. Replace as
needed.
ISO/CSC Safety Data plates
must be replaced if missing
or system will be non-
deployable.
END OF WORK PACKAGE
Содержание BOH-CARGO-12-3
