BOGE FOCUS compressor control for piston compressors
Page 3
FOCUS
1.2
Operation
1.2 Operation
Prerequisite
The compressor must be electrically and pneumatically connected, the pow-
er supply voltage must be turned on and the ball valves and / or balanced
disc stop valves between compressor and compressed air receiver must be
opened.
ENTER key
Confirmation of inputs, selection of parameters, forced idling, setting
of FC (frequency converter) parameters.
OFF key
Acknowledging when switching on the control, switching off the
compressor, switching off forced idling.
ON key
Switching on the compressor, forced idling.
Warning / Maintenance
(LED-yellow)
Flashing:
Lit:
Maintenance due – does not lead to automatic
switch-off.
Message was preliminarily acknowledged; the
cause is still recognised, however.
Fault
(LED-red)
Flashing:
Lit:
Upcoming fault, compressor automatically shut
down.
Message was preliminarily acknowledged; the
cause is still recognised, however.
Operation
(LED-green)
Flashing:
Lit:
Compressor in idling operation.
Compressor is switched on.
Emergency-Stop
pushbutton
The Emergency-Stop pushbutton interrupts the power supply for the
contactor coil. The control is still energized and generates a corre-
sponding display.
Operating / control element
Designation
Function
Caution: Risk of injury!
If the compressor is not closed there is a risk of injury due to rotating or pro-
jecting parts resp. a crushing hazard because of flaps or doors standing
open!
The compressor may only be operated with all flaps and doors closed!
