ERG7000
Page 9
Assembly STEP 3
Hardware Required
Handle Bar Assembly
A). Align the
Handle Bar (#07)
to the bracket at the front of the
Cen-
ter Post (#02)
. Insert two
Bolts (#14)
through two
Washers (#19)
,
the
Handle Bar (#07)
, and the
Center Post (#02)
(in this order, as
illustrated below).
Center Post Assembly
A). Clear the path in the cylinder tube at the front of the
Main Frame
(#01)
by
1. Turning the
Spring Loaded Knob (#11)
Counter-clockwise
three
times, then
2. Pulling the knob outward, and with the help of an assistant,
simultaneously insert the
Center Post (#02)
down into the cylinder
tube of the
Main Frame (#01)
a minimum of 4 inches.
B). Release the
Spring Loaded Knob (#11)
so that it engages into
one of the holes on the
Center Post (#02)
. For your safety and
correct assembly, please ensure the holes on the
Center Post (#02)
are facing the
Spring Loaded Knob (#11)
as shown in the illustration
below so it can be aligned and the
Spring Loaded Knob (#20)
can
fully engage.
You may adjust the
Center Post (#02)
to the height most comfortable
for you after assembly is completed. Please always check and ensure
your hole setting has been fully engaged when you secure and tighten
the
Spring Loaded Knob (#11)
.To make handlebar height
adjustments: Use one hand to hold the
Center Post (#02)
to prevent
sudden slipping, and the other hand to loosen the
Spring Loaded
Knob (#11)
by turning it
Counter-clockwise
. Make height
adjustments to your liking and then tighten the knob by turning it
clockwise. Please tighten, but do not over-tighten.
Cell Phone Holder Assembly
Attach the
Cell Phone Holder (#28)
to the bracket on the
Handle Bar
(#07)
as the illustration below.
01
11
02
28
07
14
19
#19 Washer (M10)
[2 pieces]
#14 Bolt (M10x15 mm)
[2 pieces]
#11 Spring Loaded Knob
[1 piece]
