en
4mm (5/32”)
MOUNTING OPTIONS
BELT POSITION
1. Based on clinical goals, determine the most effective position
and angle for the belt. Determine whether putting pull strap on
left or right side is best for user.
2. With the adjustment strap tightened, locate the desired
mounting points on the seating system or wheelchair frame, then
select from the mounting methods shown.
3.
Add Evoflex Belt Extender if needed to reach mounting points.
DIRECT MOUNTING TO SIDE GUARDS
Drill 6mm (1/4”) hole or use existing hole/slot to
attach belt using included fasteners.
PACKAGE CONTENTS:
Package may contain one
or more of the following:
Evoflex pelvic positioning belt with:
• (2)
M6 x 8 screws
• (2)
M6 Low-profile flange nuts
• (2) Wave spring washers
(2) Evoflex Belt Extenders with:
• (2) M6 x 8mm screws
• (2) M6 Low-profile flange nuts
4mm (5/32”)
SEAT MOUNTING BRACKET
(Requires Art. No. HW200-20 or -90)
4mm (5/32”)
BAND CLAMP OR FRAME CLAMP
(Requires Art. No. HW320 or HW310)
Attach clamp to seat tube. Attach belt using the
M6 screw included with the clamp.
T-SLOT FASTENER KIT
(Requires Art. No HKA6-12 or HKA10-14)
Use wave spring washer and low-profile flange nut
from Evoflex kit with bolt and washer from T-Slot
Fastener Kit.
Ø6mm (1/4”)
CONTROLLING
ROTATION
To increase tension
and control rotation,
use included wave
spring washer. Omit
wave spring washer to
decrease tension and
allow easier rotation.
