STEP 2
Shoulder Pads, Safety Stoppers, and Weight Holder Assembly
5
48
48
61
61
61
61
35
35
35
59
59
59
24
24
55 55
46
16
15
43
1
4
47
55
55
55
30
31
8
14
12
7
36
36
35
1. Attach the Weight Holder Support (14) to the Weight Holder (12) using one 1/2" X 3-1/4" Hex Bolt
( 46), two 1/2" Washers (55), and one 1/2" Nylon Nut (59) on the top hole of the Weight Holder
(12) and one 1/2" X 3" Hex Bolt (47) at the bottom threaded hole.
2. Attach the Weight Holder Assembly (12 & 14) to the bolts welded to the underside of the Linear
Bearing Assembly (4) and tighten with four 1/2" Washers (55) and four 1/2" Nylon Nuts (59).
3. Insert the top end of the Right Safety Stopper (15) into the top bracket on the Main Frame (1) and
then slide the bottom end into the low bracket on Main Frame (1). Check to make sure the Safety
Stopper rotates and slides freely. Insert an 8mm Locking Pin (24) into the hole on the top of the
Right Safety Stopper (15). Tap the Locking Pin with a hammer to makes sure it is permanently
attached. Repeat the procedure for the Left Safety Stopper (16).
4. Attach two 38mm Round Plugs (35) to the top on both
Shoulder Assemblies (7, 8). Attach one 31 mm
Round Plug (36) to the handles at the
top on both Shoulder Assemblies (7, 8).
5. Pull the Spring Knob (43) on the right side of
the Linear Bearing Assembly (4) and insert
the Right Shoulder Assembly (7). Attach
the Right Shoulder Pad (30) to Right
Shoulder Assembly (7) using two 5/16"
X 2-1/4" Hex Bolts (48) and two 5/16"
Spring Washers (61).
Repeat the same procedure
for the Left Shoulder
Assembly (8).
