Page
9
Assembly Instructions
A s s e m b l y S t e p 5
Hardware Required
Middle Handlebar Assembly :
Attach the
Middle Handlebar (#53)
onto the front side of the
Front Post (#31)
,
then secure it by using two
Spring Washers
(#38)
and two
Bolts (#55).
Feed the
Handle Pulse Wire (#52a)
through the neck of the
Front Post (#31)
until is sticking out of the opening. You will
need to connect the wire to the
Computer (#34)
later. Slide the
Cover of Handlebar (#54)
to the
Middle Handlebar (#53)
as
illustrated.
Computer Assembly:
Remove the
Screws (#60)
that are pre-assembled on the
Computer (#34)
and set them aside as they will be used in a
later process.
Connect the
Sensor Wire (middle) (#24b)
to the
Sensor wire
(upper) (#24c).
Then connect the
Handle Pulse Wire (#52a)
to the
Handle Pulse Wire (#52b).
Attach the
Computer (#34)
to the bracket on the
Front Post (#31)
by using four
Screws
(#60)
that were previously removed.
After complete assembly: If the computer
is
not picking up your hand pulse signal
(or you are getting inaccurate readings),
Please refer to our “Troubleshooting”
section on
Page 18
for other troubleshoot
issues.
HAND PULSE SIGNAL
Troubleshooting
#60.Screw (M4x12 mm)
[4 Pieces]
Feed the
Pulse
Sensor Wires(#52a)
through the neck
of the
Front Post
(#31)
until they are
sticking out of the
opening.
BR 2710
