Page 10
PT817 / PT890
How to Adjust the Height of Slide-Adjust Parallel Bars
Assembly Instructions
***We suggest having an assistant help you as you
adjust the height of the Slide-Adjust Parallel Bars.***
1. a.) Loosen
Knob Bolt (#14A)
by turning it counter-clockwise (about 6 turns) so that
Foam Roller
Tube (#12)
and
Foam Roller (#33)
are loosened slightly (they will be able to move slightly left and right).
2. a.) Use one hand for support on one
VKR Handle Bar (#08)
to prevent sudden sliding and another hand
to remove the corresponding
Pop-Pin (#24).
Repeat this process on the other
VKR Handle Bar (#08)
and
corresponding
Pop-Pin (#24)
.
b.) Adjust by sliding up or down the left/right
VKR Handle Bars (#08)
,
Foam Roller Tube (#12)
, and
Foam
Roller (#33)
to the set of two corresponding holes at the new height setting you wish to use.
***FOR YOUR SAFETY, always ensure both right
VKR Handle Bar (#08)
and left
VKR Handle
Bar (#08)
are set on matching height hole settings to ensure parallel bars.
3. a.) Re-insert the two
Pop Pins (#24)
in through
VKR Handle Bars (#08)
to the new height setting,
making sure you engage the same corresponding height set of holes.
b.) Tighten
Knob Bolt (#14A)
by turning it clockwise to secure the configuration. Test that the
VKR Handle
Bars (#08)
and
Foam Roller Tube (#12)
with
Foam Roller (#33)
are sturdy and secure before using them.
1
2
3
