#34 Bolt (M8x15 mm)
[8 Pieces]
#36 Bolt (M8x45 mm)
[1 Piece]
#38 Bolt (M8x55 mm)
[2 Pieces]
#40 Bolt (M8x70 mm)
[2 Pieces]
#33 Nut (M8)
[5 Pieces]
#37 Washer (M8)
[18 Pieces]
6 mm
[1 Piece]
S13-14-15-φ5
[1 Piece]
BOLT
NUT
WASHER
TOOL
#34 Bolt (M8x15 mm)
[8 Pieces]
#36 Bolt (M8x45 mm)
[1 Piece]
#38 Bolt (M8x55 mm)
[2 Pieces]
#40 Bolt (M8x70 mm)
[2 Pieces]
#33 Nut (M8)
[5 Pieces]
#37 Washer (M8)
[18 Pieces]
6 mm
[1 Piece]
S13-14-15-φ5
[1 Piece]
BOLT
NUT
WASHER
TOOL
BRB 3800
A.) Pre-Assembled Hardware Removal
Remove the four
Screws (#17)
, four
Spring Washers (#21)
, two
Arc Washers (#22)
, two
Washers (#24)
that are pre-assembled
on the top of the
Main Frame (#01)
and set them aside.
B.) Tension Controller Installation
With the help of an assistant, connect the
Sensor Wire 4 (#44)
to
Sensor Wire 5 (#45)
and
Sensor Wire 6 (#46)
to
Sensor Wire 7
(#47)
. Please refer to the illustrated diagram on the bottom and
assemble the
Tension Control (#48)
.
C.) Center Post Assembly
Once the
Tension Control (#48)
is properly installed, carefully slide
the
Front Post (#09)
in to the
Main Frame (#01)
with the tension
knob control on the right hand side. Secure both sides of the
Front
Post (#09)
using a two
Washers (#24)
, two
Spring Washers (#21)
and two
Screws (#17)
that were previously removed. Please refer
to the illustrated diagram below. Secure the front of the
Front Post
(#09)
to the
Main Frame (#01)
using two
Arc Washers (#22)
, two
Spring Washers (#21)
and two
Screws (#17)
that were previously
removed.
TENSION WIRE ASSEMBLY
Insert the tip of the
Tension Control (#48)
wire into the
Tension
Control Cable (#49)
head at an angle. Tilt the
Tension Control
(#48)
wire into the crevice and then pull upward.
SENSOR WIRE ASSEMBLY
Assembly Instructions
A s s e m b l y S t e p 2
Page 6
H a r d w a r e R e q u i r e d
#17. Screw (M8x20 mm)
[4 Pieces]
Washer
#24. Washer (M8)
[2 Pieces]
#22. Arc Washer (M8)
[2 Pieces]
#21. Spring Washer (M8)
[4 Pieces]
Bolt
