Page 6
Do not remove the
Seat (#08)
for any
reason after you have installed it.
Exercising on this unit without the
Seat
(#08)
can result in SERIOUS INJURY.
Ensure the seat is locked in place by
tightening the two knobs prior to use.
W A R N I N G
Spring Knob Operation
Turn
Spring Loaded Knob (#23)
counter
-clockwise three times.
Pull
Spring Loaded Knob (#23)
outward
and adjust
Seat Post (#28)
simultaneously.
Push
Spring Loaded Knob (#23)
back
inward until it clicks and then tighten it by
turning clockwise.
Hardware & Tool Required
A s s e m b l y S t e p 2
Seat Post Assembly
Slide the
Horizontal Seat Bar (#05)
onto the
Seat Post (#04)
with the
single point of the
Seat (#08)
pointing toward the front of the unit as
shown in the diagram. Secure by screwing the
Knob Bolt (#35)
through
one
Washer
(#36)
, the
Seat Post (#04)
, then the
Horizontal Seat Bar
(#05).
This knob can be loosened to adjust the distance of the seat from
the handle bars. Please tighten the knob after making an adjustment,
but do not over tighten the knob. If the
Seat Post (#04)
is not already
pre-assembled, please insert the
Seat Post (#04)
into the mouth of the
post that is protruding from the top of the
Main Frame (#01)
. Please
ensure that the hole on the
Seat Post (#04)
is facing the same side as
the
Spring Loaded Knob (#23)
so it can be aligned with the
corresponding hole on the
Main Frame (#01).
To use the safety-featured
Spring Loaded Knob (#23)
, use one hand
to hold the
Seat (#08)
to prevent sudden slipping and the other hand to
loosen the knob by turning it counter-clockwise . Adjust the seat height
to your liking and then tighten the knob by turning it clockwise. Please
do not over-tighten.
Remove the
Knob Bolt (#35)
and
Washer (#36)
that are pre-installed
on the
Horizontal Seat Bar (#05)
and set them aside.
Washer
#36. Washer (M8)
[1 Piece]
Others
Tool
[1 Piece]
#23. Spring Loaded Knob
[1 Piece]
#35. Knob Bolt (M8x15 mm)
[1 Piece]
55
40
1
2
3
4
55
40
1
2
3
4
STEP3:
Assembly Instructions
BF 718
