BODY BIKE Classic, Инструкция по эксплуатации

Страница: 19 / 24

MAINTENANCE
T he Kevlar® pad on the BODY BIKE Synthetic Brake
has an expected durability of a minimum of 1500
hours, so eventually the brake pad will be worn. To
ensure that the brake pad is correctly mounted,
it has been pre-fitted to the block, and it is only
possible to purchase the complete brake block. Go
to page 22.
Inspect the Kevlar® brake pad after the first month
and hereafter every 3rd month. The Kevlar® brake
pad should be replaced before it is worn through
and reveal the black rubber.
To get to the brake block, it is necessary to remove
the right side cover from the cycle. See figure 14-16
1) Loosen all the screws in the side cover and
remove them as well as the bottle holder.
2) Remove the side cover by sliding the side cover in
the direction of the steer. See figure 16
3) Release tension completely on the brake. Coun-
terclockwise will loosen the resistance. See figure 7.
4) Remove the two screws holding the brake block
to the frame by using an 8 mm wrench, see figure
19.
REPLACING THE BRAKE BLOCK SERVICE HATCH
Figure 17
Figure 18
In order to remove the service hatch, use a PZ2 drill bit
and a drill. Remove the 2 screws and then the hatch.
See figure 17.
Quick acces to adjust the poly-v belt. See figure 18
019