Bodet Opalys Date, Инструкция по установке и эксплуатации

Страница: 27 / 48

I - INITIAL VERIFICATION
Thank you for choosing a BODET clock. This product has been carefully designed for your
satisfaction based on ISO9001 quality requirements. We advise you to read this manual
thoroughly before attempting to manipulate the clock.
These indicate important comments.
Keep this booklet during all the life of your clock, so that you can refer to it each time it is
necessary.
1.1 Unpacking the clock
Unpack with caution and check the contents of the packaging. It must contain :
-
The Opalys date clock clipped on to its wall holder,
- A 12W 240V/24V power supply,
-
A fixation kit (2 2 rawlplugs),
- A cleaning kit (impregnated antistatic cloth)
-
This booklet,
-
with option, a table holder.
Remark : when unpacking, some segments of the clock can be activated. This is not a
default, connect the low voltage power supply and after a few seconds the problem will
disappear.
Versions : A descriptive label is fixed to the back of the clock :
938222A RAD FI = the clock is radio-synchronised by a France Inter antenna.
938224A RAD DCF = the clock is radio-synchronised by a DCF antenna.
938233A AFNOR / IMP = the clock is receiving (driven by a master clock
delivering impulses, minute or 1/2 minute from 12 to 48V, on a parallel line, or
coded time AFNOR NFS-87500A).
938242A RAD DHF = the clock is radio-synchronised by a DHF transmitter.
Bodet accepts no responsibility for any use not in compliance with these instructions.
Any modification to the product will invalidate the warrantee .
1.2 Backup
All the parameters for the clock are saved permanently even in the absence of power.
The clocks keep their time bases during a few days thanks to their internal battery.
27