IV - TIME SETTING MENU
4.1 NTP clock
The receiver (NTP) clocks set themselves to the correct time automatically.
After a reset or time change, the NTP clocks wait for three coherent time messages before
synchronising.
Remark : See the chapter “Technician Menu” page 40 to parameter to time distribution.
Caution
:
if there is no NTP message reception:
-
on start-up, the clock displays only the two dots.
-
It is still possible to change the time but the clock displays only the two dots.
4.2 Independent quartz clock
The NTP receiver clocks can be configured
independently; in this case you will need to set
the clock to the correct time.
The [SEL] button enables you to shift between
the different menus and the [+]
8
button enables
you to scroll through the setting values.
Each time [SEL] is pressed, the option that is
flashing is validated.
To set the clock to the correct time, proceed as follows :
1. a
On the initial powering up, the time is initialised at 00h00
01/01/2000. Press [SEL] for 2 seconds : the hour flashes.
b
Press [+] until the required hour is shown (the display of hours takes
account of the 12 /24 hr mode, see paragraph 5 page 32).
2. a
Validate the hour by pressing [SEL] : the minutes flash.
b
Press [+] until the required minute is displayed. To synchronise your
clock to the nearest second, select the current 1 and as
the minute pips, validate by pressing [SEL] ;
The internal second counter is then reset to zero and starts up.
3. a
a Having validated the minutes : the year flashes.
28
8
Maintaining pressure on the [+] button for longer enables you to increase the values rapidly
(minutes, hours, days, etc).
