10
Blockholder set
The blockholder set is composed of the front air distributor, the log guard, the door
deflector and the vermiculite (with BG logo).
To take it apart, remove the 4 M5 fastening screws (8mm socket) located under the floor on
the heating element. Then remove the blockholder set, taking care not to damage the
vermiculite on the sides.
Sides
To remove the vermiculite from the sides, after having removed the vermiculite baffle, the
floor and the front fence, start removing the front vermiculite (towards you). Lift these
vermiculites from below with your index finger and tilt them inwards.
Then remove the other 2 pieces of vermiculite by moving the top of the brick towards you
and tilting it inwards.
Back
The vermiculite bricks at the back are held in place by a clamping spring on the left. First
remove this spring leaf. Then, to remove the bricks from the back, raise the bricks 5mm, tilt
the bottom of the bricks towards you, and lower the bricks to release them.
Finally remove the metal wedge on the right.
Rear air distributor
Once the back bricks have been removed, you can remove the rear air distributor by
unscrewing the 4 M5 screws (8mm socket). Then lift the rear air distributor to remove it (use
a screwdriver to lift it up if necessary).
Reassembling
For reassembly, repeat the same operations in the reverse order.
1.8.
Installation and connections.
(!) At this stage, the paint has not been baked yet. It is therefore fragile. Consequently, the
appliance must be handled with the utmost care.
Check the strength, stability and load-bearing capacity of the structure where the appliance
is installed. Check the various minimum installation dimensions. Protect combustible
materials near the stove with 50mm of fire resistant thermal insulation.
Once the installation has been prepared in accordance with the above regulations, proceed
with the installation of the appliance.