Boca Systems M144Ai, Руководство пользователя

Страница: 15 / 40

15
EXPRESS Install
Testing the Connection
1. Check that you have made all connections and with your
computer powered on, check for a dial tone on a phone set
if one is connected.
2. If you do not have communications software already
installed, you may install the software supplied with the
On-Line EXPRESS. Refer to the diskettes and manual for
installation instructions. After installing and starting your
communications software, enter terminal mode.
IMPORTANT: If you are not in terminal mode and you type AT
commands at the DOS prompt, a “Bad Command or File
Name” message will result.
3. Type in ATZ followed by ENTER and the modem will
respond with OK after a few seconds.
4. Type ATH1 followed by ENTER and you should hear a
dial tone. To adjust speaker volume, refer to your
communications software or use the ATL command.
5. Type ATH followed by ENTER to put the modem “on-
hook”. This confirms that the modem has been
successfully installed into your computer. Your modem is
now ready for use. Continue now with your
communications software and documentation. Make sure
your software is set to the same communications port
assigned to your modem by COMCHECK.