BocaFlasher.com
5 of 7
Installation Manual
HPNFC-RT
REV 04-2019
4. CONNECT DMX CABLES TOGETHER
(AS SHOWN ON JOB SPECIFIC DRAWING)
HPNFC-HO
HPNFC-HO
HPNFC-RT
BF-01
INSTALLATION OF CLIPS FOR LIGHT FIXTURES WITH TWIST LOCK CONNECTIONS:
1. Light fixtures that have twist lock connections on each end may be installed in areas where the surface plane may be at slightly
different levels between light fixtures. Also, the light fixtures do not have to be in straight alignment and can be laid out to
different angles and patterns.
2. Using a chalk line or laser mark a line on the flat surface where the 2 clips for the 1st. fixture are to be mounted. (See Figure: A)
3. Snap in the first light fixture into the clips (see section 2 installing fixtures into clips).
4. Using a chalk line or laser mark a line on the flat surface where the 2 clips for the 2nd fixture are to be mounted, this fixture
can be placed on a slightly different plane as long as the cord between the 2 fixtures is long enough. Also, this fixture can be
placed at a different angle than the first fixture (see figure 4).
5. Snap in the 2nd light fixture into the clips (see section 2 installing fixtures into clips).
6. Continue this process until all light fixtures are installed according to the job specific layout drawings.
7. Connect fixtures to power per section 5 and 6.
various angles and levels.
IMPORTANT NOTE:
Not screwing fixtures together represents an
incomplete install and voids the warranty if any fixtures are damaged
as a result of improper installation
4a
Rotate fixture to see bottom and note
each label.
4b
Cross-reference with Job Specific
Drawing.
4c
Connect Male and Female end
caps in order shown on job specific
drawings.
4c
Push together until you hear a
“CLICK” then twist until secure.
“CLICK!”
