24
1. Place the spacer on the X stepper motor and install the assembly onto the frame.
2. Install and tighten the 4 M3 x16 machine screws.
3. Install the Y stepper motor to the Y assembly with 4 M3 x 10 machine screws.
4 Tighten the machine screws.
5. Set the height on the Y threaded coupler so that the Allen key is flat against the top of
the Y assembly.
6. Set the height of the X threaded coupler so that it is approximately 1 mm less than the
round spacer thickness. (This will give the build platform clearance)
4. Install and tighten both of the Z stepper motors 4 M3 x10 mm machine screws.
5. Tighten the 8 coupler machine screws so that the gap is even and parallel on both
sides.
If the Z stepper motors have flats, then align the flats on the motor shafts as seen
in the diagram.
Содержание RP8
Страница 1: ...RP9 Assembly Instructions ...
