Bob's Space Racers Incorporated Big Dog Kiddie Dog Pounder, Руководство пользователя

Страница: 16 / 37

BOB’S SPACE RACERS® BIG DOG (KIDDIE DOG POUNDER)™ ARCADE
16
SCORE SENSOR REPLACEMENT
IMPORTANT: CHECK TO SEE WHAT SENSOR
NEEDS TO BE REPLACED BEFORE PROCEEDING.
WHEN THE GAME SAYS "GET HELP" PRESS THE
PROGRAMMING BUTTON TO SEE WHAT SENSOR
IS BAD. THE SENSORS ARE NUMBERED #1-#6,
WITH #1 BEING ON THE LEFT HAND SIDE AS
VIEWED FROM THE FRONT.
1. Turn off AC Power and unplug the game
2. Open the back of the game by removing the 8
retaining screws around the edge of the opening.
3. Carefully remove the rear panel and set on floor.
4. Replace the sensor pair by removing the connectors
and the retaining fasteners.
5. Be sure the new sensors are installed correctly and
fastened securely
DO NOT USE METAL FASTENERS AS THEY COULD
DAMAGE THE SENSOR BOARDS. USE ONLY THE
PLASTIC FASTENERS SUPPLIED.
More of these fasteners can be obtained through our service department.
*SPECIAL NOTE – SENSORS MAY ONLY BE DIRTY AND MAY NOT BE BAD. TRY CLEANING SENSORS AND
REFLECTIVE AREAS TO CORRECT THE PROBLEM BEFORE REPLACING THEM.*
PLAYFIELD LIGHT REPLACEMENT
1. Turn off AC Power and unplug the game
2. Open the back of the game by removing the 8 retaining screws
around the edge of the opening.
3. Carefully remove the rear panel and set on floor.
4. Remove the bad bulb by unsnapping the retainer clip from the
holder and pressing the red lock on the fixture itself.
5. Install the new bulb
6. Assemble in reverse order.
NOTE: BE SURE BOTH THE RED ‘LIGHT RELEASE BUTTONS’ AND RETAINER CLIP ARE FULLY ENGAGED
TO PREVENT THE BULB FROM FALLING OUT OF THE FIXTURE AND CAUSING DAMAGE.
SCORE
SENSOR
SET #1
PLAYFIELD
LIGHTS
(REAR VIEW)
PLAYFIELD
LIGHTS
(INSIDE VIEW)