BN Thermic Ltd,
34 Stephenson Way,
Crawley, RH10 1TN
Tel: +44 (0) 1293 547361
Email: [email protected]
Web: www.bnthermic.co.uk
This product conforms to EU Directive 2002/96/EC.
This appliance bears the symbol of the crossed waste bin. This indicates that, at the end of its useful life, it must not be disposed of as
domestic waste, but must be taken to a collection centre for waste electrical and electronic equipment. It is the user's responsibility to
dispose of this appliance through the appropriate channels. Failure to do so may incur penalties established by laws governing waste
disposal.
6. COMMISSIONING
Note:
The heater runs hot so please wait till the heater has cooled down before moving / adjusting.
WARNING! Ensure you read, understand and apply the safety instructions in Section 1 before using the heater.
6.1 Perform Insulation and Earth continuity tests.
6.2 Switch on the heater(s) and confirm that the ceramic elements are working.
6.3 Ensure each heater aims its warmth into the target area by adjusting the heater angle(s) as required, and then tighten the
bracket bolts keeping the heater(s) firmly in place.
6.4 Although the fitting can be tilted between 30º & 45º in the vertical plane, check & ensure that the fitting remains within 10º
of
the horizontal plane as the elements are only designed for horizontal operation.
6.5 The User / Customer should be made aware of all aspects of the operation and safety advice. Keep the instructions safely for
future reference.
6.6 In unoccupied premises it is recommended that the heating system is switched off and isolated from the electrical supply.
7. MAINTENANCE
Note:
Before examining or carrying out any maintenance ensure the heater has cooled down and is disconnected from the mains
supply.
7.1
BN Thermic ceramic heaters contain no moving parts and therefore very little maintenance is required other than to ensure
that there is no excessive build-up of dust/dirt on the reflectors or elements as this can cause overheating and premature
failure. Depending on installation conditions, a heater should be regularly inspected, but at least once per year.
8. SPARES
Spare elements are available from your distributer. Please quote the model number shown on the silver rating label of the heater.
NOTE: It is our policy to continually improve products and as such we reserve the right to alter specifications and component parts without prior
notice.
IMPORTANT:
No liability is accepted for incorrect use of this product.
WARRANTY:
Your BN Thermic product is guaranteed for one year from date of purchase. We will
repair or replace at our discretion any part found to be defective. We cannot assume any
consequential liability. This guarantee in no way prejudices your rights under common law and is
offered as an addition to consumer liability rights.
REGISTER:
Activate your warranty by registering online at www.bnthermic.co.uk and retain this
installation data for future reference.
CH2-30INS-v01
