2. INTRODUCTION & SPECIFICATION
This heater produces a totally dry heat, no condensation, no gas, no fumes and no smell. It reaches maximum heat output within 4
minutes of being turned on. It has a highly polished aluminium reflector for maximum heat efficiency. The bracket
allows “up and
down” and “side to side” adjustment. The heater can be used for both industrial or domestic applications.
Model
CH2-30(B)
Power
3000W
Input supply
220-240v
Dimensions (W x H x D)
375 x 376 x 100mm
Weight
5.7kg
Minimum Mounting Height
2.0M
Recommended Mounting Height
2.5M
Recommended Maximum Mounting Height
3.5M
Safety Distance from Heater
1.5M
3. MOUNTING INSTALLATION
3.1 WALL MOUNTING (Fig.1)
❑
IMPORTANT!
The following points should be noted:
The heater
should always have a minimum clearance of 450mm from a ceiling
and at least 1500mm from any object (see table above).
❑
IMPORTANT!
Ensure that the mounting surface is capable of
supporting the weight of the heater.
❑
IMPORTANT!
The heater should ideally be mounted at 30º to 45º from
the vertical, whether wall or ceiling mounted.
❑
IMPORTANT!
The mounting bracket must be sufficiently earthed.
3.1.1 Remove the wall mounting bracket from the box.
3.1.2 Before drilling, ensure that there are no wires or water pipes in the area
where the heater is to be placed.
3.1.3 Use the bracket as a template. Fix the metal bracket to the wall by
means of the three holes and appropriate fixings (not supplied).
3.1.4 Refit the heater onto the bracket with the bolt provided.
3.1.5 Adjust the angle of heater to direct heat where required, between 30°
and 45° (see Fig.1).
3.2 CEILING MOUNTING
3.2.1
An optional pack containing 4 hooks and nuts is available from your
supplier to enable the heater to be ceiling mounted on suitable chains.
3.2.2
Insert these 4 hooks into the M6 threaded holes in the back corners of
the heater and lock in place with the supplied nuts.
3.2.3
Heaters should be ideally angled at 30º to 45º from the vertical when
ceiling mounted.
Fig.1
