BN Products DIAMOND DBD-20M, Инструкция по эксплуатации

Страница: 2 / 8

Products that make money, save money and add value to your bottom line
Page • 2
READ ALL INSTRUCTIONS AND SAVE
THIS DOCUMENT FOR REFERENCE.
1. Keep hands away from all moving parts and roll-
ers while operating.
2. Dress properly. Loose clothing or jewelry can
get caught in moving parts. Wear sturdy boots
with non-skid soles. Steel toed boots and safety
glasses are recommended.
3. Keep children and bystanders away. Distractions
can cause you to lose control.
4. Do not overreach. Keep proper footing and bal-
ance at all times. This enables better control of
the power tool in unexpected situations.
5. Stay alert. Watch what you are doing and use
common sense when operating a power tool. Do
not use a power tool while you are tired or under
the influence of drugs or alcohol. A moment of
inattention while operating power tools may re-
sult in serious personal injury.
6. Do not exceed the maximum number of bars
that can be bent at one time. Please refer to the
Rebar Bender Roller Selection Chart
7. When positioning the bar between rollers, make
sure to lay it flat on the machine surface. Failure
to do so may cause the rebar to fly out.
8. Do not expose tool to rain or use in damp loca-
tions. Do not use tool in presence of flammable
liquids or gases. Keep work area well lit. If the
tool is used outdoors, keep it covered when not
in use and protect it from rain or water.
9. Do not try to bend materials harder than “Grade
60 or 600N/mm2” as they will either crack and
fly out or cause machine failure.
10. Disconnect tool from receptacle when not in use.
Disconnect the tool when servicing or changing
rollers to prevent accidents.
11. Keep tool clean at all times for best and safest
performance. Follow instructions for lubricat-
ing and changing parts. Keep hands dry and
free of oil or grease. Inspect switches, tool cords
periodically and have them repaired or replaced
by an authorized service center if damaged.
Check moving parts for alignment and binding
as well as for breakage and improper mount-
ing. Damaged parts should be repaired or re-
placed by an authorized service facility unless
otherwise indicated in this instruction book.
1. Moving bending roller
2. Center roller
3. Adjustable stopper
4. Main switch
5. Pilot lamp
6. On/Off Button
7. Angle setter (dial type)
8. Angle stopper (Left &
Right)
9. Emergency stop button
10. Plug-in for foot switch
11. Roller set (not shown)
12. Foot Operated Switch
(not shown)
Bender Handling Instructions
DBD-20M Rebar Benders (0-180 degree)
Important: When using electric tools, basic safety precautions should always be
followed to reduce the risk of electric shock and personal injury, please note the
followings items: