BNCP-100-18V Rivet Gun_TM_8-15
Page | 6
BN Products-USA, LLC.
I.
(1) Front sleeve
II.
(2) Clamping sleeve
(3) Riveting machine
(4) Clamping jaws (3 parts)
Remove the front sleeve (1) and the
clamping sleeve (2) from the device (3)
and remove the clamping jaws (4)
from the clamping sleeve (2).
III. Oil the clamping sleeve (2) with Molykote®
D grease (5).
IV.
Hold the clamping sleeve (2) so that its
forward part is faced down.
V.
Place the clamping jaws (4) in the clamping
sleeve (2) with their smooth sides facing
outwards.
VI.
Mount the clamping sleeve (2) with the
new clamping jaws (4) and finally replace
the forward sleeve (1).
Battery Notes
Keep the battery away from moisture and water.
Only store the battery at temperatures from 0° to
45°C. Do not leave the battery in the car, e.g. in
summer. If the battery is working for significantly
shorter periods of time after a recharge, it is weak
and needs to be replaced.
Please consider the notices for disposal.
Maintenance and service
Take the battery out of the BNCP-100 Riveting Gun
for transportation and storage. Risk of injury oc-
curs if you inadvertently press the power switch.
Keep the BNCP-100 Riveting Gun and the ventila-
tion slots clean to ensure good and safe operation.
If the BNCP-100 Riveting Gun should fail despite
the meticulous manufacturing and quality control
procedures, the repairs should be done by an
authorized service center for BN Products-USA
electric riveting devices.
